- Connects to PC via USB port.
- Embed high speed CPU
- Ultra-high programming speed.For example, Programs 28F320B3 in less than 30 seconds, and Verify it less then 11 seconds.
- 48 ZIP universal drivers. No adapter is needed for DIP chips 48, No family PACK is needed for any package. Universal DIP, PLCC, QFP, TSOP, PSOP, SOIC, SSOP, SDIP, uBGA, CSP adapters up to 48 pins. Device specific adapters up to 100 pins are available.
- 0.7V-25.5V/256 levels drivers voltage.
- Support FLASH, EPROM, EEPROM, MCU, PLD
- Test TTL/COMS and SRAM.
- Device insertion and poor-pin-contact check protect chip from destroyed. Over-current protection protects pin-drivers from damaged.
- Surge check and protect
- Auto-run mode starts programming automatically upon detection of chip insertion.
- The software support Windows 98/ME/NT/2000/XP More option: Reload and save buffer Verify after read. Prompt the Lock bits after change devices. Alarm before Program/Erase/Lock. Automatic find EEPROM devices. SYSTEM REQUIREMENTS
- Operating system: Windows98/98SE/ME/NT/2000/XP
- Processor: Pentium or Higher - 16 MB RAM minimum, 32 MB recommended
- Hard disk with 8 MB free space
- USB port interface GENERAL
- Power: 100 to 240 VAC, auto-switching
- Freq. range: 47 to 63 Hz
- Power consumption: 25 W
- Operating temperature: 5 to 45°C (41 to 113°F)
- CE Certified

ВОПРОСЫ?